- ISO 9001 approved
- TÜV Rheinland approved
- Link-Up approved supplier to the UK rail industry
- Successfully tested for vibration endurance
- Avoids COSHH implications of alternative construction methods
- Independent load tests on finished handrail structures to international standards
ISO 9001 Approval
Cert No: GB96/6175
Our Quality Management System in the United Kingdom has been approved to ISO9001 (formerly ISO9002) since 1995. Our Australian subsidiary operates a Quality Management System which is separately certified to ISO9001. We regard this as a minimum standard to maintain.
TÜV Rheinland – Product Safety Type Approval
The core range of Interclamps is subject to periodic rigorous testing and continuous product safety type approval by TÜV Rheinland, the leading independent test house across the globe.
British/European Standard BS EN 60068-2-6 Environmental Testing (Vibration)
In accordance with BS EN 60068-2-6, a British UKAS-Accredited test house conducted seven resonance (vibration) endurance tests, each of six hours duration, plus an additional six hour swept endurance test between the frequencies of 74Hz and 87Hz on one axis. After each resonance endurance dwell, the setscrews were visually checked for any movement. Throughout the whole test programme, there was no evidence of any loosening of the setscrews. Further technical information relating to the test is available on request.
Australian Standard AS 1657-2013 - Fixed Platforms, Walkways, Stairways & Ladders: Design, Construction & Installation
Typical Interclamp installations of our Traditional Range, DDA Assist and Pedestrian Barriers have been successfully proof load tested in both C42 and D48 sizes in compliance with the procedures specified in AS 1657-2013, by an independent NATA and ISO/IEC 17025 accredited test house.
Australian Standard AS 1428.1-2009 Design for Access & Mobility Part 1: General Requirements for Access – New Building Work
Interclamp DDA Assist fittings may be used to build handrails that conform to AS 1428.1-2009. As this standard is for finished structures, it is important that the correct Interclamp fittings and other materials (most notably tube, fixings and existing structure or substrate to which the Interclamp structure is attached) are chosen for each application and that the complete structures are both suitably designed and installed to meet the requirements of the standard.
Australian Market only: Interclamp® Compliance Statement
A Compliance Statement, which makes reference to the most relevant Australian Standards is available on request. It includes details of Inspection, Testing & Servicing requirements, in order to satisfy the needs of the standards.
Beam tests for uniformly-distributed loads have been successfully carried out by an independent British load test facility. Further details are available on request.